Enclosure for the PRNTR board in OnShape

I finally got annoyed enough by the mess of cables and decided to finish an enclosure for the PRNTR board. I finished designing the bottom half.

This is what it looks like in the OnShape assembly:

View from another angle:

Closeup of the final assembly – the outer fan duct:

A look over the whole board:

And finally this is what it looks like, when powered up:

All 3D component designs are available in OhShape here.

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.