SMD stencil printer is so cool

If you can’t recognize what this is, here is an explanation.

When creating PCBs, one can order a stencil – usually from a thin sheet of stainless steel. On this stencil, there are cut small holes (with a laser cutter) where one is supposed to apply solder paste on the PCB.

So the operation is: you align the stencil on top of the PCB; then squirt some solder paste on top of the stencil; then use a flat “applicator” to smudge the solder paste over the stencil holes. In the end, you lift the stencil up, and you end up with the solder paste applied in a thin layer over the solder pads on the PCB.

To aid in this whole process is this contraption – a stencil printer. You align the stencil on the device and put come L shaped holders on the bottom to hold the PCB in place. The bolts on the bottom are to help to align the stencil and the PCB. When the alignment is achieved you put the PCB in the holder on the bottom; lower the stencil; apply solder paste; lift the stencil; remove the PCB. The whole solder paste application takes about 1 minute.

I should have gotten it sooner. My only regret is not getting a larger size printer, as you can see the stencil frame is a bit larger than the printer base – it still works though.

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.